Disc brakes consist of a Disc Brake Rotor, which is attached to the wheel, and a Caliper, which holds the Disc Brake Pads. Hydraulic pressure from the Master Cylinder causes the Caliper Piston to clamp the Disc Brake Rotor between the Disc Brake Pads. This creates friction between the pads and rotor, causing your car to slow down or stop.
Drum brakes consist of a Brake Drum attached to the wheel, a Wheel Cylinder, Brake Shoes and Brake Return Springs. Hydraulic pressure from the Master Cylinder causes the Wheel Cylinder to press the Brake Shoes against the Brake Drum. This creates friction between the shoes and drum to slow or stop your car.
The Parking Brake uses Cables to mechanically apply the brakes (usually the rear brake.) This is used to prevent the car from rolling when not being driven.
Anti-Lock Brakes: A System Built For Safety
Computer-controlled anti-lock braking systems (ABS) are a recently developed safety feature. When sudden stops are made, the ABS prevents wheel lock-up. The system is comprised of wheel-speed sensors that monitor wheel rotation, computer-controlled hydraulics that pulse the brakes on and off rapidly, and the on-board computer.
The brake system equipped in your vehicle is a culmination of over 100 years of technological innovation, transforming crude stopping mechanisms into dependable and efficient pieces of speed variation equipment. While brake systems vary by make and model, the basic system consists of disc brakes in front and either disk or drum brakes in the rear. Connected by a series of tubes and hoses, your brakes are linked to each wheel and the master cylinder by said network, which supply them with vital brake fluid (hydraulic fluid).
The brake system is actually composed of two kinds of systems---Hydraulics and Friction Materials. Here's what happens within these systems between the time your foot hits the brake pedal and your car stops.
Phone: (407) 614-8912
401 Franklin St
Ocoee, FL 34761
Types of Brakes
401 Franklin St., Ocoee, FL. 34761 (407) 614-8912